BIJOU_CONTEMPORAIN

Bienvenue sur mon blog

08/07/2011

DIY MARNI BRACELET

Classé dans : bracelet,COUP DE COEUR,DIY,Sammie-Jo COXON (UK),techniques textiles,VIDEO — bijoucontemporain @ 0:04

………. bon …. ça doit être l’effet de la chaleur, hypnotisée par le chant incessant des grenouilles et « shootée » au parfum des daturas ……….

alors ….. un bracelet MARNI …..  à acheter …..

http://2.bp.blogspot.com/-nt6r4R1_d8U/TdKa2CYU1qI/AAAAAAAAAeo/IurlvpK1h0M/s400/Screen+shot+2011-05-17+at+16.53.05.png
Marni Two-tone woven bangle available here

 

OU à faire soi-même (DIY, do-it-yourself)

http://4.bp.blogspot.com/-TX4NBDPqE3c/TdKajkkXHDI/AAAAAAAAAek/qJ_B7IdzMdo/s640/DIY_Marni-Bracelet_v2.jpg

 

DIRECTIONS:

This pattern is known as the « Cobra Stitch, » which sounds very fancy and difficult, but is actually pretty simple. If you need extra help, you can always check out this video for some additional, visual instruction! 

1. For the base of your bracelet, cut a 1-foot long piece of the thicker ribbon (5/8″ Orange, in this case). You also will need to cut a metre long piece of the thinner pink ribbon and the thinner orange ribbon (1/4″ Shocking Pink and Orange, for those of you keeping track).

2. Take the thin pink and orange ribbons and fuse their ends together with a small amount of glue, so that you have one long piece of ribbon. Wait five minutes for the glue to completely dry before moving on to the next step.

3. Tape the top of the base ribbon—the thicker, 5/8″ Orange—to a steady, flat surface and center the fused, thinner ribbon underneath it. Each side of the fused ribbon will serve as Ribbon A and Ribbon B (to follow example above).

4. To begin the Cobra Stitch, take Ribbon A and cross it over the base ribbon and under Ribbon B to make a loop.

5. Bring Ribbon B under the base ribbon and through Ribbon A’s loop. Once knotted through, pull Ribbon A and B equally so they create a knot around the base ribbon.

6. Continue this pattern, alternating the lead ribbon from side to side. (Note: if your pattern starts to spiral, you’re not alternating sides.)

7. Continue braiding the bracelet until you have reached a desired length then double knot both ends. The pattern should be 3/4 the size of your desired length for the bracelet, as the remaining 1/4 will be used to tie around the wrist.—Jessica Baker

 

 

MERCI au blog de ! :-)

 

Image de prévisualisation YouTube

 

 


Une réponse à “DIY MARNI BRACELET”

  1. office chairs dit :

    office chairs…

    VIDEO…

Laisser un commentaire

 

MODELSCULPT |
Valérie Salvo |
dochinoiu |
Unblog.fr | Créer un blog | Annuaire | Signaler un abus | Françoise Fourteau-Labarthe
| Aidez les jeunes artistes
| Tableaux de Christian Maillot